Milk pre-processing steps-storage at 4 °C (with durations of 48, 72 or 96 h) and methods for microbiological stabilization of milk (1.4 μm microfiltration, thermization, thermization + bactofugation, pasteurization) are performed industrially before 0.1 µm-microfiltration (MF) of skimmed milk to ensure the microbiological quality of final fractions. The objective of this study was to better understand the influence of these pre-processing steps and their cumulative effects on MF performances (i.e., transmembrane pressure, and transmission and recovery of serum proteins (SP) in the permeate). Results showed that heat treatment of skimmed milk decreased ceramic MF performances, especially after a long 4 °C storage duration (96 h) of raw milk: when milk was heat treated by pasteurization after 96 h of storage at 4 °C, the transmembrane pressure increased by 25% over a MF run of 330 min with a permeation flux of 75 L.h-1.m-2 and a volume reduction ratio of 3.0. After 48 h of storage at 4 °C, all other operating conditions being similar, the transmembrane pressure increased by only 6%. When milk was 1.4 µm microfiltered, the transmembrane pressure also increased by only 6%, regardless of the duration of 4 °C storage. The choice of microbiological stabilization method also influenced SP transmission and recovery: the higher the initial heat treatment of milk, the lower the transmission of SP and the lower their recovery in permeate. Moreover, the decline of SP transmission was all the higher that 4 °C storage of raw milk was long. These results were explained by MF membrane fouling, which depends on the load of microorganisms in the skimmed milks to be microfiltered as well as the rate of SP denaturation and/or aggregation resulting from pre-processing steps.
Keywords: 1.4 μm microfiltration; cold storage; fouling; heat treatment; serum protein.